|lailemof||TARİX: ÇƏRŞƏNBƏ, 2014-11-05, 9:08 AM | Message # 1|
N. Mariana Islands
|The Bundt Cake of Barad |
Using <a href=http://www.blackfridaytiffany2014.com>tiffany and co outlet</a> the cardboard paper towel tubes as the core, first I constructed the tower itself. Since the tower was not <a href=http://www.blackfridaytiffany2014.com>tiffany and co outlet</a> <a href=http://www.tiffanysale-uk.co.uk>tiffany uk</a> made of cake, this happened a couple of days before the party.
The paper towel tubes were sleeved together to the approximate height that I wanted the tower to be (less the forky bit at the top). The spacing of the three tiers of the tower was marked out by eye, so that I could most efficiently ignore it later.
Four <a href=http://www.outlet-canada-goose.com>canada goose jackets</a> discs were cut from foamcore two large discs for the base of the tower and the top of the first tier and two medium discs for the second tier. Two flat strips were used to bulk out the top tier a little bit. All of the discs had a hole in the center for the cardboard tube to slip through.
Now, the smart way to make the discs would have been to determine the desired diameter of each level by taking measurements from a photo of <a href=http://www.tiffanyjewelryoutlet.co.uk>tiffany and co uk</a> the tower from the movie, calculating accurate proportions based on the size of my Bundt pan and the height of the cardboard tube, then using a compass to mark out each disc, thus ensuring that the discs were sized consistently and the center holes were, well. centered. This is, of course, exactly not what I did.
Instead, I scoured the kitchen for bowls, cans, ramekins, bottle caps, and other circular objects that looked sorta like the right sizes, then traced around them with a pencil onto the foamcore. A spice jar turned out to be close to the right diameter for the center hole, and this was placed pretty haphazardly in the "center" of each circle, then traced.
The discs were cut out using a razor knife, and hot glued onto the center tube in almost precisely not where I had marked the <a href=http://www.saclouisvuittonparis.org>sac louis vuitton</a> tier levels earlier. I also glued a few scrap strips of foamcore onto the tube lengthwise, just for additional support. A measurement was taken of the height of each tier, and strips of poster board were cut at something resembling this measurement, then glued into place to form the outer surface of the tower.
<a href=http://www.tiffanyblueaustralia.org>tiffany rings australia</a> <a href=http://www.cybermondaytiffanydeals.com>cyber monday deals tiffany</a> <a href=http://www.tiffanyjewelryoutlet.co.uk>tiffany uk outlet</a>